It should be referred to by duty holders as the primary standard against which to benchmark. supporting systems failure, such as when pneumatic or hydraulic systems lose pressure and allow a ram to fall.ĭuty holders should use the Australian Standard AS 4024 Safety of machinery series as the standard that gives the current state of knowledge for the safeguarding of machinery and plant.ineffective lock-out and isolation of power systems.interlock guards used as a shortcut to start the machine.closed limit switches which are not used, causing interlock switches to be overridden.single light beam safeguard devices can be switched off.mechanisms from interlock switches can be removed to override the guards.interlocked guards that can open while parts are still moving or running down.operators able to remove guards for maintenance and not replacing them.openings in the guards where the operator can easily reach through to dangerous parts.guards not securely fastened and easily removed while the machine is in use. no guarding on machines at all – letting operators reach into dangerous parts of the machine.WorkSafe New Zealand has identified a number of trends where employers have been prosecuted for injuries and fatalities to staff and contractors through using machinery. ill health from hazardous chemicals or lack of oxygen.Duty holders must take all practicable steps to make sure machinery in the workplace is designed safely and is adequately guarded to reduce the risk of injuries or harm. The HSE Act and HSE Regulations place responsibilities on many different persons, including machinery and plant designers, manufacturers, suppliers, installers and operators, employers and owners of machinery. When using this guideline, consider the unique demands of your workplace and industry there may be other hazards and risks not covered in this guideline. It gives duty holders advice on how to use machinery safely and meet their duties under the Health and Safety in Employment Act 1992 (HSE Act) and the Health and Safety in Regulations 1995 (HSE Regulations). The Best Practice Guidelines for the Safe Use of Machinery outlines the hazards that come with using machinery in the workplace, potential injuries and how best to control these hazards. This guidance will be progressively reviewed and either updated, replaced with other guidance, or revoked. Please read this guidance in conjunction with all relevant industry standards that apply to you as a PCBU. While this guidance has not been updated to reflect current work health and safety legislation (the Health and Safety at Work Act 2015 and regulations), it may still contain relevant information and practices to keep workers and others healthy and safe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |